Hotends and nozzles

100k NTC thermistor for measuring the temperature in a hot end or heated bed.With 1m wires attached.  ..

12V 40W heater cartridge for a hotend length: 20mmDiameter: 6mmCapacity: 40W..

24V 40W heater cartridge for a hotendlength: 15mmDiameter: 6mmCapacity: 30WThis heater has no plug. It is intended for screw terminals...

24V 40W heater cartridge for a hotendlength: 20mmDiameter: 6mmCapacity: 40WThis heater cartridge is compatible with 3D printers like the:Creality CR-10S proCR-XEnder 3Ender 3 proAnet E10This heater has no plug. It is intended for screw terminals...

This thin kapton tape is used to insulate a hotend or to keep the thermistor on a heated bed in place. Width: 5mmLength: 33mHeat resistant to 280℃..

..

All metal hotends have, as the name suggests, only metal parts and can thus withstand higher temperatures.This makes them excellent for printing materials like nylon.   This hotend is an E3D v5 clone.Complete with heater cartridge and thermistor.Filament diameter: 1.75 mmNo..

All metal hotends have, as the name suggests, only metal parts and can thus withstand higher temperatures.This makes them excellent for printing materials like nylon.   This hotend is an E3D v5 clone.Complete with heater cartridge and thermistor.Filament diameter: 1.75 mmNo..

This extruder grips the filament from 2 sides instead of from only one side as most standard extruders do. |It also has a 1:3 gear reduction, allowing for much more precise filament extrusion and much less force required from the stepper motor...

This extruder grips the filament from 2 sides instead of from only one side as most standard extruders do. |It also has a 1:3 gear reduction, allowing for much more precise filament extrusion and much less force required from the stepper motor...

0.2mm nozzles are used for 3D printing fine details. Because it is made of brass, this nozzle has excellent heat conductivity, causing it to warm up fast.This nozzle is compatible with the following 3D printers:bq Hephestosbq Hephestus 2bq Prusa i3 Hephestosbq Witboxbq Witbox 2Creality CR-10Creality..

0.3mm nozzles are used for 3D printing fine details. Because it is made of brass, this nozzle has excellent heat conductivity, causing it to warm up fast.This nozzle is compatible with the following 3D printers:bq Hephestosbq Hephestus 2bq Prusa i3 Hephestosbq Witboxbq Witbox 2Creality CR-10Crea..