Printbeds

100k NTC thermistor for measuring the temperature in a hot end or heated bed.With 1m wires attached.  ..

A sheet of PEI for printing on.Width: 220mm Length: 220mm Thickness: 0.5mmThis PEI sheet comes with 3M 468MP transfer tape for sticking it on your heated bed...

A sheet of PEI for printing on.Width: 220mm Length: 220mm Thickness: 0.5mmThis PEI sheet comes with 3M 468MP transfer tape for sticking it on your heated bed...

..

Suitable for 12V and 24V. With cables, LEDs and resistor.Connected for 12V, but i think the cables are a bit thin...

3mm thick aluminium plate.Suitable for 12V and 24V No LEDs or resistor.See: http://reprap.org/wiki/PCB_Heatbed#MK3_ALU-Heatbed_Dual_Power for more information.  ..

The standard heated bed for a  repRap delta 3d printer. Diameter: 200mmVoltage 12V..

The standard heated bed for a  repRap delta 3d printer. Diameter: 200mmVoltage 12V..

Its function is to hold the first plastic coat in order to hold the start of the printing steady, avoiding undesirable mistakes. 3DLAC is the perfect substitute for Kapton tape and other types of fixers due to cost-saving and its easy application. A light 3DLAC mist over the surface is enough to h..

..

Kapton tapeA good printing surface for ABS (110℃) as well as PLA (60℃).The "wet mount method" as shown on https://www.youtube.com/watch?v=yVTWXGqNB2I te works very well for applying the tape without bubbels or openings. Width: 50mmLength: 33mHeat resistant to 280℃..